Support Forum (EN/FR)

Velleman Projects
It is currently Sat May 25, 2013 8:23 am

View unanswered posts | View active topics


Board index » Kits (Soldering projects – Projects à souder) » General

All times are UTC




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
cdbintexas
PostPosted: Mon Oct 24, 2011 5:08 pm 
Offline
New User
New User

Joined: Mon Oct 24, 2011 4:56 pm
Posts: 1
My k8061 worked well until today when I attempt to connect with demo or diagnostic interface, I get a "CPU FAIL" message.
What do I do next? Is there a spare parts department who can sell me a new cpu? I have not modifed code so the test must be working as intended.
Top
 Profile  
 
VEL255
PostPosted: Mon Oct 24, 2011 7:46 pm 
Offline
Velleman Support
Velleman Support

Joined: Mon Dec 11, 2006 12:03 pm
Posts: 3910
Location: Belgium
You can test the CPU operation.
- Disconnect the USB cable.
- Connect the 12Vdc power supply to the board.
If the CPU is OK, the LED LD12 should be now flashing and the LEDs LD13-LD20 should be lit and LD1-LD8 should be off.

The "CPU FAIL" indicates that the communication between the two CPUs on the board fails. The cause to this may be the optocouplers IC1, IC2 or any other defective component on the board.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Kits (Soldering projects – Projects à souder) » General

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group