Support Forum (EN/FR)

Velleman Projects
It is currently Thu Oct 30, 2014 6:53 pm

All times are UTC




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: K8048 Not writing to PIC
PostPosted: Sat Oct 31, 2009 11:47 am 
Offline
Member
Member

Joined: Sat Oct 31, 2009 11:32 am
Posts: 1
hi there
When i try to write the demo HEX file to the Pic supplied with the kit i get the following error message: "NO PIC ON BOARD, PROGRAMMER MUST BE SET TO PGM MODE, PIC TYPE MISMATCHED WITH SOFTWARE". When i put power on the board all LEDs act as they supposed to but LED2 stays on. When i first put power on the board the jp3 and jp4 jumpers were bridged to each other(incorrectly), could this have damaged something?


Top
 Profile  
 
PostPosted: Mon Nov 02, 2009 10:18 am 
Offline
User avatar
Velleman Support
Velleman Support

Joined: Fri Dec 08, 2006 8:11 am
Posts: 755
Location: Belgium
Please search into this forum, there are a lot op toppics about this.
I think, it couldn't be damaged.
Check the power supply (15V at least, serial cable,...).


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group