It is currently Tue Aug 22, 2017 8:31 pm

All times are UTC




Post new topic Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Mon Feb 06, 2017 11:55 pm 
Offline
Member
Member

Joined: Mon Feb 06, 2017 11:34 pm
Posts: 5
Just finished building my K8200. Everything went according the the instructions except for adjusting the motor voltage. My voltages are E-.83, Z-.78, Y-.74, X-.79 and none of them will let me adjust the voltage down to the .425 to .55.


Top
 Profile  
 
PostPosted: Tue Feb 07, 2017 3:15 pm 
Offline
Senior Member
Senior Member

Joined: Tue Mar 27, 2007 12:24 am
Posts: 3431
Location: USA
The first time I did this I had the same problem.
After many attempts I had to get a magnifying glass and to see what was going on.
Turns out the screw driver I was using was to big.
0.55 works best.


Top
 Profile  
 
PostPosted: Tue Feb 07, 2017 4:23 pm 
Offline
Member
Member

Joined: Mon Feb 06, 2017 11:34 pm
Posts: 5
Ok. Thanks for the advice. Best I could tell it looked like they were turning but I'll get a magnifying glass and try again.


Top
 Profile  
 
PostPosted: Fri Feb 10, 2017 12:54 am 
Offline
Member
Member

Joined: Mon Feb 06, 2017 11:34 pm
Posts: 5
Thanks for the tip. Even with the magnifying glass it was almost impossible to see if the screws were moving. I had to take a small jewelers screwdriver and file the tip down, but was able to get them adjusted to .55v each.

Thanks Again.


Top
 Profile  
 
PostPosted: Fri Feb 10, 2017 3:01 pm 
Offline
Senior Member
Senior Member

Joined: Tue Mar 27, 2007 12:24 am
Posts: 3431
Location: USA
Glad to hear everything worked out.

I should warn you.
3D printing is highly addictive.
Lol

Happy printing!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group