It is currently Tue Apr 25, 2017 2:32 pm

All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Feb 15, 2017 2:23 pm 
Offline
Member
Member

Joined: Fri Sep 02, 2016 12:20 pm
Posts: 4
Hey joint users,

i had a Problem last week that, the extruder was blocked by the used Filament. I build the Extruder apart and unfortunatly I demaged the Thermister. So I changed this one with a new NTC (100k as required) and first all seamed to work proper. When I start Repetier, the temperature of the Extruder is about 19-20 °C which seams to be right. As the printing starts, the Extruder is heated, but the temperature on repetier shows always the same temperature. I already checked if the shown temperature is just not updated, but it seams to work proper. The problem is now, that the printing w'ont start, due to the fact, that Repetier always displays a wrong temperature.
Does anyone know, where the problem may be? Do I have to change something in the firmeware?

Kind regards,
Fetsch92.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group