It is currently Thu May 25, 2017 9:55 pm

All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Feb 07, 2017 8:23 am 
Offline
Member
Member

Joined: Tue Feb 07, 2017 8:10 am
Posts: 1
Hello!

The k8200 i'm currently using recently stopped extruding any filament as soon as i press the "start print" button. Manually extruding works well, and it oozes when the extruder is heated up but not printing. Once it starts printing, it's like it retracts the filament too far, and there isn't even any oozing due to the heat.

I'm using repetier host v1.6.2 and cura engine for slicing; if anyone has any ideas what might be the issue i would be very grateful.

Thanks in advance


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group