It is currently Fri Aug 18, 2017 8:58 am

All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Jun 27, 2017 9:57 am 
Offline
Member
Member

Joined: Wed Jun 14, 2017 8:26 pm
Posts: 9
Hi,

I am currently using a k8200 with astroprint, the other day one of my A4988 driver boards failed and I replaced it with a DVR8825 driver, I re calibrated my steps per mm and the 20 x 20 x 20 mm cube I printed was within the correct margin.

I started a large print this morning that uses the majority of the y axis, the issue is it didn't start the print in the center of the bed, the right hand side of the print is nearly touching the right hand side of the y axis, thus leaving around a 20mm space on the left hand side.

Now prior to changing the driver board the prints were pretty much in the center, are there some settings I can change or am I better trying to calibrate the y axis again maybe with a larger print. something like a 100 x 100mm cube.

Here are some images to show you what I mean.

http://imgur.com/a/hLquW

Cheers.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: Exabot [Bot] and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group