It is currently Tue Apr 25, 2017 12:28 pm

All times are UTC




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Feb 14, 2017 9:55 am 
Offline
Member
Member

Joined: Wed Jun 17, 2015 11:15 am
Posts: 190
Location: NL
Hi, I was wondering this is an issue for a Velleman ticket?
I bought a new nozzle, did the heater block around it and tried to fasten the setscrew. The block didn't clamp enough, could turn the block around the nozzle. Fastened the screw more, but without result. I got two measurements. The original nozzle:
Image
and the new one:
Image
It seems to be a slight difference but apparantly enough to leave the block loose.

After that I replaced the old nozzle and it turned out that I had fastened the setscrew so much that the screw thread of the block is broke now. So I have to replace the heater block too!

Velleman, can you please give me an answer? Thank you in advance.


Top
 Profile  
 
PostPosted: Wed Feb 15, 2017 7:51 pm 
Offline
Member
Member

Joined: Wed Jun 17, 2015 11:15 am
Posts: 190
Location: NL
@velleman, be a sport and let your light shine on this issue...


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group