It is currently Sat Feb 25, 2017 9:02 am

All times are UTC




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Feb 12, 2017 9:09 pm 
Offline
Member
Member

Joined: Sun Feb 12, 2017 8:47 pm
Posts: 1
HI,

i have had a hard time to update the firmware of my brandnew k8400

thought i should do a step throug because i didnt find a nailed answer to the problem....

1. Download Arduino ide ( V1.8.1 )
2. Load up Marlin.ino ( vertex-m1-v1.4-h2\Marlin\Marlin.ino ) as an example.
3. In Arduino IDE go to Tools -> Board -> Board Managment
4. Search for "Arduino AVR Boards"
5. Downgrade to 1.6.11 !!! ( Down-Left dropbox Version than Install)
6. Check if it compiles...
7. Dont forget the Boardjumper ( marked as JPROG )
8. Hit Upload
9. Wait.... after upload it will recompile and flash the firmware ( caution progressbar stops when coimpiling is done... but will not show you flashing... just WAIT. takes abou a minute or less. )
10. reset printer.

please tell me if i have forgot somethin...


regards MK


Top
 Profile  
 
PostPosted: Mon Feb 13, 2017 8:47 am 
Offline
Senior Member
Senior Member

Joined: Thu Oct 03, 2013 6:19 am
Posts: 2249
Location: Namur, Belgium
Use Arduino 1.0.x as stated in the instructions. Later versions won't work.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group