It is currently Tue Aug 22, 2017 6:46 pm

All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Mon Aug 07, 2017 6:33 am 
Offline
Member
Member

Joined: Sun May 17, 2015 7:21 am
Posts: 196
Location: AUDIGNON (LANDES)
Hello, is it possible to print both the supports and the part with the same extruder (the one on the left, number 2) in the version of repetier host 1.6.2? The software systematically refuses and does not take into account what I ask: to know to print my part and the supports with the extruder 2 and therefore makes the slicing with the extruder 1. I use the configuration two heads, everything is Configured correctly, for example: printing the supports with "any of the extruders", printing the object parameterized with the extruder 2, but it is impossible, it always uses the extruder 1 for the part and shifts me The printing of the supports with the extruder 2. I do not know if I was very explicit. It is annoying because this new version would suit me better. Thank you for your answers.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group