It is currently Sat Feb 25, 2017 12:20 am

All times are UTC




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Tue Feb 14, 2017 6:58 pm 
Offline
Member
Member

Joined: Mon Feb 13, 2017 7:05 pm
Posts: 3
Goedendag beste 3d printer bouwers en gebruikers.

Apetrots was ik toen mijn eerste 3d printer, die ik als bouwpakket had gekocht, meteen reageerde toen de stekker in de muur ging.
Minder blij was ik, toen ik zag dat na het geven van een printopdracht de peek isolator begon te smelten.

De temperatuurs terugkoppeling is er wel want ik zag de temperatuur op het display staan.

Is deze temperatuurs weergave wel in overeenstemming met de temperatuur die in de kop aanwezig is ??

Maw wat maakt mijn dual head zo heet dat de peek isolator begint te smelten?

met vriendelijke groet: Pietjebel


Top
 Profile  
 
PostPosted: Wed Feb 15, 2017 8:51 am 
Offline
User avatar
Velleman Support
Velleman Support

Joined: Thu Dec 26, 2013 12:42 pm
Posts: 585
This is an english only forum.
This is so everyone can understand and can help each other.

Please check if the temperature sensor is properly placed.
If it's not correctly placed it measure the air around the hotend.

Best Regards
VEL337


Top
 Profile  
 
PostPosted: Thu Feb 16, 2017 1:40 pm 
Offline
Member
Member

Joined: Mon Feb 13, 2017 7:05 pm
Posts: 3
Thanx for your response.

If this becomes the solution, it will be an easy modification.


best regards....


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group