It is currently Sat Jul 22, 2017 2:37 am

All times are UTC




Post new topic Reply to topic  [ 348 posts ]  Go to page Previous  1 ... 20, 21, 22, 23, 24
Author Message
PostPosted: Sun Jul 02, 2017 3:59 pm 
Offline
Member
Member

Joined: Fri Mar 24, 2017 5:20 pm
Posts: 12
My self, purchased a 12v 180 watt supply from amazon and a PE at the same time.
All installed and working.
Bought replacement mounting screws and glued (epoxy) to the heatbed base. Very strong and stable. Need to give a good 48hrs to fully cure.


Well worth the time and money.


Top
 Profile  
 
PostPosted: Sun Jul 09, 2017 6:34 pm 
Offline
Member
Member

Joined: Thu May 18, 2017 6:58 pm
Posts: 7
Sounds awesome.
How long does it take to get the heatbed to right temp?


Top
 Profile  
 
PostPosted: Tue Jul 11, 2017 9:20 pm 
Offline
Member
Member

Joined: Fri Mar 24, 2017 5:20 pm
Posts: 12
funderare wrote:
Sounds awesome.
How long does it take to get the heatbed to right temp?


No time at all. Only printing PLA at the moment so about 4 mins to reach 60 degrees.
Purchased parts from amazon.
Power supply: KeerSen DC 12V 15A 180W Switching Power Supply £14.99
Hrph 3D Printer Heated Bed Power Module High Current 210A MOSFET
Anycubic NTC 3950 100K Thermistor. I chose these as the Vertex firmware was already set up for it.
YCNK 12Feet 14 Gauge (AWG) Super Soft and Flexible Silicone Rubber Wire.

Total cost around £40.


This is the most worth while upgrade to the vertex printer I've done so far.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 348 posts ]  Go to page Previous  1 ... 20, 21, 22, 23, 24

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group