It is currently Sat Jul 22, 2017 2:39 am

All times are UTC




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sun Jun 25, 2017 1:07 pm 
Offline
Member
Member

Joined: Sat Jun 24, 2017 12:39 pm
Posts: 1
Location: Ieper - Belgium
Hello,

Since the repetier software is using the Cura engine I tought of using Cura , so I can use 1 program for all diferent printers.
So I've managed to get the same functional code in Cura as is made in the repetier programm.
See the image here:
Image

The only diference is that the M109 is generated on a different time in the code.
Repetier = after the Z axis has gone down to Z=0.3mm
Cura = before the Z axis has gone down.

What happens with the Cura code , is that while going down 4cm of the 7,5 the printer stops and goes into error.
"ERROR MAX TEMP, please reset".

I've tried preheating it to 190°C and then moving the Z-axis down with the control command, then this error does not occur.
So this must mean there is no deffect in the wires of the temperature sensor.

--> is this firmware related? Does the printer do any check while going down?
Image


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group