It is currently Wed Aug 23, 2017 3:25 pm

All times are UTC

Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Sat Mar 18, 2017 5:02 pm 

Joined: Sat Mar 18, 2017 4:05 pm
Posts: 1

I bought a HPS140 6 years ago (if my memory is correct) and was using it from time to time until recently.
But a few months ago, it just stop displaying correct measurement. Now when I start it I can only see an horizontal bar that will not move from the top of the screen, and any tension apply to the probe will not make the measurement changes.
Changing settings will not change anything, I can set 20v/div or 1v/div and it will always display a straight line on top of the screen with a Vmax indicator of about 6.8% of the v/div selection (0.68v for 10v/div, 0.034v for 0.5v/div...)

what can I possibly do about it ? is it something that I can repair ?

here is photo of what it display on startup (nothing connected to the probe), probe connected or not is the same.


Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group